Siemens sinamics dcp - 5.6.3 Terminal Module TM15; 5.6.3.1 Description; 5.6.3.2 Safety instructions

Electrical connection
5.6 Additional system components
SINAMICS DCP
74 Operating Instructions, 09/2019, A5E34382853K
5.6.3 Terminal Module TM15
5.6.3.1 Description
The TM15 is a terminal expansion module for snapping onto a mounting rail according to EN
60715. The number of available digital inputs and outputs within a drive system can be
expanded with the TM15.
Table 5- 12 Interface overview of the TM15
Type
Number
DRIVE-CLiQ interfaces
2
Bidirectional digital inputs/outputs 24 (electrical isolation in three groups each with eight DI/DO)
5.6.3.2 Safety instructions
WARNING
Non-observance of the safety instructions
If the safety instructions in Chapter 1 are not observed, accidents can occur involving
severe injuries or death.
• Make sure that the safety instructions are observed.
WARNING
Fire through overheating due to insufficient ventilation clearances
Inadequate ventilation clearances cause overheating with a risk for personnel due to smoke
and fire. This can also result in more downtimes and reduced service lives of the Terminal
Module.
• For this reason, it is imperative that you maintain the 50 mm clearances above and
below the Terminal Module.
NOTICE
Damage through the use of incorrect DRIVE-CLiQ cables
Damage or malfunctions can occur on the devices or system when incorrect or unreleased
DRIVE-CLiQ cables are used.
• Only use suitable DRIVE-CLiQ cables that have been released by Siemens for the
respective application.