SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
153
7.1 Operation
7.1.1 Basics
7.1.1.1 Parameters
Parameter types
The following adjustable and display parameters are available:
● Adjustable parameters (can be written and read)
These parameters have a direct effect on how a function responds.
Example: Ramp-up and ramp-down time of the setpoint ramp
● Display parameters (can only be read)
These parameters are used to display internal variables.
Example: Current voltage on side 1 and side 2
Figure 7-1 Parameter types
All these parameters can be read via PROFIBUS or PROFINET and changed using p
parameters using the mechanisms defined in the PROFIdrive profile.
To Next Page
Loading...
