Electrical connection
5.6 Additional system components
SINAMICS DCP
116 Operating Instructions, 09/2019, A5E34382853K
5.6.5.8 Protective conductor connection and shield support
The following diagram shows a typical Weidmüller shield connection clamp for the shield
supports.
Protective conductor connection M4 / 1.8 Nm
Shield connection terminal, Weidmüller company, type: KLBÜ CO1, order number:
Figure 5-39 Shield support and protective conductor connection of the TM150
Damage or faulty operation due to incorrect shielding and impermissible cable lengths
If the correct shielding procedures and the permissible cable lengths are not observed, the
machine can be damaged or may malfunction.
• Only use shielded cables.
• Do not exceed the cable lengths stated in the technical data.
To Next Page
Loading...
