Operation
7.19 Drive Control Chart (DCC)
SINAMICS DCP
378 Operating Instructions, 09/2019, A5E34382853K
7.19.1 Loading the DCC technology option into the drive unit memory
Loading the DCC technology option into the drive unit is usually performed with STARTER
and with the SINAMICS DCP takes about 7 min. During this process, the entire DCB library
with a scope of approx. 2 MB data is transferred to the drive.
To accelerate this process, the SINAMICS DCP supports an alternative option for
transferring the DCB library to the drive. With this method, the process is shortened to less
than 5 min:
●
Step 1
In STARTER, open a project that includes a SINAMICS DCP drive with at least one DCC
chart. In the shortcut menu (right mouse button), select "Load into file system" (only
possible in the offline mode).
Figure 7-86 Loading into the file system
● Step 2
A dialog, "Load into file system", opens. Choose "Select target" and select an empty
folder on a local hard drive.
To Next Page
Loading...
