Electrical connection
5.6 Additional system components
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
81
5.6.3.6 Dimension drawing
Figure 5-24 Dimension drawing of Terminal Module TM15, all data in mm and (inches)
5.6.3.7 Installation
Installation
1. Tilt the component backwards slightly and attach it to the DIN rail using the hooks.
2. Swivel the component onto the DIN rail until you hear the mounting slide at the rear latch
into position.
3. Slide the components along the mounting rail to either the left or right up to their final
position.
To Next Page
Loading...
