Siemens sinamics dcp - 5.6.1.6 Assembling the 120 kW device

Electrical connection
5.6 Additional system components
SINAMICS DCP
68 Operating Instructions, 09/2019, A5E34382853K
5.6.1.6 Assembling the 120 kW device
Figure 5-17 Installing the CBE20
1. Release the two screws at the lower side of the device and remove the front panel
2. Release the nuts
①, remove the bracket
3. Loosen the screws
③
4. Remove the cover plate
③ (screw)
5. Push in the CBE20
④
6. Tighten the screws
③ again
7. Fasten the cover plate
③