Siemens sinamics dcp - 6.2 Commissioning using the BOP20 operator panel; 6.2.1 Requirements

Commissioning
6.2 Commissioning using the BOP20 operator panel
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
121
6.2 Commissioning using the BOP20 operator panel
6.2.1 Requirements
SINAMICS basics
If you are not yet familiar with SINAMICS basics (parameters, drive objects, BICO
technology, etc.), please read Chapter "Basics (Page 153)" before starting commissioning.
BOP20 operator panel
If you are not yet familiar with the BOP20 operator panel, please read Chapter "Parameter
assignment via the BOP20 (Basic Operator Panel 20) (Page 171)" before starting
commissioning.
Notation of the parameters
Expressed in full, a parameter consists of
the drive object + parameter number + index, with the following notation:
(oo)pxxxxx[ii]
for indexed parameters
(oo)pxxxxx
for non
-indexed parameters
To make these easier to read, in this chapter the drive object specification has been omitted
from all parameters belonging to the "Drive control" drive object (= drive object 2).
For example, the specification p50076[1] refers to parameter (2)p50076[1] (= drive object 2,
parameter 50076, index 1).