Index
SINAMICS DCP
446 Operating Instructions, 09/2019, A5E34382853K
Locked functions, 386
Overview, 385
Parameters that can be changed, 387
Password check, 387
Password security, 385
L
LEDs
Terminal Module TM15, 80
Terminal Module TM150, 113
Terminal Module TM31, 99
M
MBAP, 280
Media redundancy, 270
Modbus Application Header, 280
Modbus TCP, 275
Activate via interface X1400, 277
Communication via data set 47, 283
Function codes used, 280
Mapping tables, 278
Modbus register to the parameters of the Control
Unit, 278
Parameterizing communication for X1400, 277
Read and write access, 280
Reading and writing parameters, 283
O
Online operation with STARTER, 256
Options
G63, 69, 71, 72
P
Password
Changing, 392
PROFIBUS
Diagnostics, 215
PROFIBUS diagnostics data, 215
Channel-related diagnostics, 218
Data sets DS0/DS1 and diagnostics alarm, 219
Identifier-related diagnostics, 216
Standard diagnostics, 216
Status messages/module status, 217
PROFIdrive, 183
Controller, Supervisor, Drive Unit, 184
Device classes, 184
Message classes, 211
Message classes for PROFINET, 212
PROFIBUS message classes, 215
Reading parameters, 205
Write parameter, 207
PROFINET
Data transfer, 252
Diagnostics, 212
Forwarding messages via diagnostics
channels, 271
PROFINET IO, 246
Addresses, 249
IRT, 264
With IRT, 248
With RT, 248
Protective conductor connection and shield support
Terminal Module TM150, 116
R
Real-time communication, 248
Recycling, 423
Residual risks, 18
Ring topology, 270
Scalance, 270
RT
Comparison with IRT, 265
RT class
Setting, 265
RT classes
Send cycles, 266
Update cycles, 266
S
Safety guidelines
Electrostatic sensitive devices, 16
Safety instructions
Electromagnetic fields, 13
General safety instructions, 11
Terminal Modules, 74, 87, 105
Sequence of objects in the telegram, 253
SINAMICS Link
Activation, 318
Bus cycle, 312
Configuration example, 319
Configuring, 314
Requirements, 311
Synchronous cycle, 312
Transmission time, 312
To Next Page
Loading...
