Siemens sinamics dcp - 5.6.1.7 Technical data; 5.6.2 Terminal Module Cabinet TMC (option G63)

Electrical connection
5.6 Additional system components
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
69
8. Attach the bracket and fasten with ① nuts
9. Re-attach the front panel and tighten the two screws at the lower side of the device
5.6.1.7 Technical data
Table 5- 8 Technical data
Communication Board CBE20
6SL3055-0AA00-2EBx
Unit
Value
Max. current requirements (at 24 V DC)
A
DC
0.1
Power loss W 2.4
Weight
kg
< 0.1
5.6.2 Terminal Module Cabinet TMC (option G63)
The Terminal Module Cabinet (TMC) enables the simple connection of the CUD standard
signals (X177) via spring-loaded terminals in an easily accessible area of the control cabinet.
See Chapter "Ordering information for options and accessories (Page 27)" for ordering data.
Figure 5-18 Terminal Module Cabinet
The CUD is equipped with a "Cabinet Board".
During installation, connectors X1 and X2 on the adapter board must be connected to
connectors X1 and X2 on the TMC with the supplied cables (3 m). The cables must be laid in
a cable duct.
Terminal block assignment, see "Figure 5-20 Terminal/connector arrangement on the
"Cabinet Board" (Page 71)".