Siemens sinamics dcp - 5.6.3.9 Connector coding

Electrical connection
5.6 Additional system components
SINAMICS DCP
84 Operating Instructions, 09/2019, A5E34382853K
5.6.3.9 Connector coding
A series of coding elements ("coding sliders") are supplied with each Terminal Module
TM15.
Connector coding
1. Insert at least one coding slider at the required position.
2. Remove the associated coding lug at the connector.
①
Insert a coding slider.
②
Cut off the coding lug on the connector.
Figure 5-27 Procedure for encoding a connector
To avoid wiring errors, unique coding patterns must be defined for the connectors X520,
X521 and X522.
Possible patterns:
● 3 connectors on one component are encoded differently (i.e. X520, X521 and X522).
● Different component types are encoded differently.
● Otherwise identical components are encoded differently on the same machine, (e.g.
several TM15-type components).