Siemens sinamics dcp - 7.7.7 Messages and parameters

Operation
7.7 Communication via Modbus TCP
SINAMICS DCP
288 Operating Instructions, 09/2019, A5E34382853K
7.7.7 Messages and parameters
Faults and alarms (see DCP List Manual)
•
A01925
Modbus TCP connection inte
rrupted
•
F08501
PN/COMM BOARD: Setpoint timeout
•
A08526
PN/COMM BOARD: No cyclic connection
•
A08555
Modbus TCP comm
issioning fault
Overview of important parameters (see the SINAMICS DCP List Manual)
•
p0978[0...n]
List of drive objects
•
r2050[0...19]
CO: IF1 PROFIdrive PZD receive word
•
p2051[0...24]
CI: IF1 PROFIdrive PZD send word
•
r2053[0...24]
IF1 PROFIdrive diagno
stics PZD send word
•
p8835
CBE20 firmware selection
•
p8839[0...1]
PZD interface hardware assignment
•
p8840
COMM BOARD monitoring time
•
r8850[0...19]
CO: IF2 PZD receive word
•
p8851[0...24]
CI: IF2 PZD send word
•
r8853[0...24]
IF2 diagnostics PZD send
•
r8854
COMM BOARD state
•
p8920[0...239]
PN Name of Station
•
p8921[0...3]
PN IP address
•
p8922[0...3]
PN default gateway
•
p8923[0...3]
PN Subnet Mask
•
p8924
PN DHCP mode
•
p8925
PN interfaces configuration
•
p8940[0...239]
CBE2x Name of Station
•
p8941[0...3]
CBE2x
IP address
•
p8942[0...3]
CBE2x Default Gateway
•
p8943[0...3]
CBE2x Subnet Mask
•
p8944
CBE2x DHCP mode
•
p8945
CBE2x interfaces configuration