Operation
7.1 Operation
SINAMICS DCP
170 Operating Instructions, 09/2019, A5E34382853K
Copy drive data set
Set parameter p0819 as follows:
1. p0819[0] = Number of the drive data set to be copied (source)
2. p0819[1] = Number of the drive data set to which the data is to be copied (target)
3. p0819[2] = 1
Copying is started.
Copying is finished when p0819[2] = 0.
Function diagrams (see SINAMICS DCP List Manual)
● 8560 Command Data Sets (CDS)
● 8565 Drive Data Sets (DDS)
Overview of important parameters (see the SINAMICS DCP List Manual)
● p0170 Command data set (CDS) number
● p0809 Copy Command Data Set (CDS)
● p0810 BI: Command Data Set, CDS bit 0
● p0819 copy Drive Data Set (DDS)
● p0820 BI: Drive Data Set selection DDS bit 0
● p0821 BI: Drive Data Set selection DDS bit 1
To Next Page
Loading...
