Operation
7.1 Operation
SINAMICS DCP
176 Operating Instructions, 09/2019, A5E34382853K
Parameter display
The parameters are selected in the BOP20 using the number. To call up the parameter
display from the status display, press the "P" key. You can search for the parameters you
require using the arrow keys. To display the parameter value, press the "P" key again. You
can toggle between the drive objects by simultaneously pressing the "FN" key and an arrow
key. You can toggle between r0000 and the parameter that was last displayed by pressing
the "FN" key in the parameter display.
Figure 7-9 Parameter display
To Next Page
Loading...
