Siemens sinamics dcp - Page 249

Operation
7.6 Communication via PROFINET IO
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
247
IO devices: Drive units with PROFINET interface
● SINAMICS DCP with inserted CBE20
Cyclic communication using PROFINET IO with IRT or using RT is possible on all drive units
equipped with a PROFINET interface. This means that error-free communication using other
standard protocols is guaranteed within the same network.
Note
PROFINET for drive technology is standardized and described in the following document:
PROFIBUS profile PROFIdrive
- Profile Drive Technology
PROFIBUS User Organization e. V.
Haid
-und-Neu-Strasse 7
D
-76131 Karlsruhe
You can obtain the current version from "PROFIBUS and PROFINET International (PI)
(
https://www.profibus.com/download/profidrive-profile-drive-technology/)".
O
rder Number 3.172, spec. Chap. 6
•
IEC 61800-7
Note
PROFINET for drive technology is stand
ardized and described in the following document:
•
PROFIBUS profile PROFIdrive – Profile Drive Technology
Version V4.1, May 2006
PROFIBUS User Organization e. V.
Haid-und-Neu-Strasse 7, D-76131 Karlsruhe, Germany
http://www.profibus.com, Order Number 3.172, spec. Chapter 6
•
IEC 61800-7
Note
For a CUD with inserted CBE20, the cyclic PZD channel is deactivated for PROFIBUS DP.
By setting parameter p8839
= 1, the PZD channel can be reactivated, see Chapter "Parallel
operation of communication
interfaces (Page 193)".
See also
Profibus address (http://www.profibus.com)