Communication
9.3 Communication via PROFIBUS DP
Function Manual
Function Manual, 01/2011, 6SL3097-4AB10-0BP3
609
7. The "I/O address" column displays the start address for every drive object.
Select the start address of the data of the drive object to be read. This is 268 in the
example.
If the complete data of the Publisher are not read, set this via the "Length" column. You
may also offset the start address for the request, so that data can be read out in the
middle of the drive object telegram portion.
Figure 9-30 Configuring the slave-to-slave communication nodes
8. The "Data Exchange Broadcast - Overview" tab shows you the configured slave-to-slave
communication relationships which correspond to the current status of the configuration
in HW Config.
Figure 9-31 Data Exchange Broadcast - Overview
To Next Page
Loading...
