Reinforcement plates
4.2 Installation
SINAMICS S120 Combi
100 Manual, Edition 07/2012, 6SL3097-4AV00-0BP3
4.2 Installation
The reinforcement plates for the S120 Combi must be mounted in each case. For mounting,
holes that correspond to the drilling pattern below must be drilled in the mounting panel.
s
s
s
s
s
s
Figure 4-1 Drilling pattern for mounting the reinforcement plates
Holes:
4 X Ø 4.8 mm
Screws to be used:
M4 x 10 (ISO 7045 (DIN 7965), ISO 7380, DIN EN ISO 1207, ISO 1580M4)
Tightening torques:
Initially tighten by hand (0.5 Nm), then tighten with 1.8 Nm
To Next Page
Loading...
