Siemens SINAMICS S120 Combi - S1 DIP Switch

DC link components
8.2 Control Supply Module CSM
SINAMICS S120 Combi
Manual, Edition 07/2012, 6SL3097-4AV00-0BP3
155
8.2.3.5 S1 DIP switch
Table 8- 11 DIP switch S1
Terminal Designation Technical specifications
1 Changeover switch, single
operation / parallel operation
2 Dummy contact
(not used)
Left: Single operation
Right: Parallel operation
Changing over the output characteristic
The changeover is only made in the no-voltage state.
',3VZLWFK
&KDQJHRYHU
VZLWFKVLQJOH
RSHUDWLRQ
SDUDOOHORSHUDWLRQ
'XPP\FRQWDFW
QRWXVHG
/()7 5,*+7
6
Figure 8-7 DIP switch on the upper side of the component
When delivered, "single operation" is set. Both switches are set to the left.
Note
The DIP switch must be set to "single operation" when operating the Control Supply Module
on the S120 Combi.