Additional system components
10.1 Terminal Module TM54F
SINAMICS S120 Combi
Manual, Edition 07/2012, 6SL3097-4AV00-0BP3
175
10.1.3.2 X500/X501 DRIVE-CLiQ interfaces
Table 10- 2 X500/X501 DRIVE-CLiQ interfaces
Pin Signal name Technical specifications
1 TXP Transmit data +
2 TXN Transmit data -
3 RXP Receive data +
4 Reserved, do not use
5 Reserved, do not use
6 RXN Receive data -
7 Reserved, do not use
8 Reserved, do not use
A + (24 V) Power supply
B M (0 V) Electronics ground
The blanking covers for the DRIVE-CLiQ interfaces are included in the scope of delivery.
Blanking covers (50 pieces) order number: 6SL3066-4CA00-0AA0
10.1.3.3 X514 power supply for digital outputs and sensors
Table 10- 3 Terminals for the power supply X514
Terminal Designation Technical specifications
+ Power supply
+ Power supply
M1 Electronics ground
+
M
M1 Electronics ground
Voltage: 24 V DC (20.4 V – 28.8 V)
Current consumption: max. 4 A
1)
Max. current via jumper in connector: 20 A
Max. connectable cross-section: 2.5 mm²
Type: Screw terminal 3 (see the chapter titled "Control cabinet installation and EMC/Connection system")
Note
The two "+" and "M1" terminals are jumpered in the connector. This ensures that the supply
voltage is looped through.
1)
including the current consumption for the digital outputs and to supply the sensor.
To Next Page
Loading...
