System overview
1.4 Standards
SINAMICS S120 Combi
Manual, Edition 07/2012, 6SL3097-4AV00-0BP3
27
Standards* Title
IEC 60287-1 to -3 Cables - Calculation of the current carrying capacity
Part 1: Current carrying capacity equations (100 % load factor) and calculating the losses
Part 2: Thermal resistance -
Part 3: Main sections for operating conditions
HD 60364-x-x
IEC 60364-x-x
DIN VDE 0100-x-x
VDE 0100-x-x
Erection of power installations with nominal voltages up to 1000 V;
Part 200: Definitions
Part 410: Protection for safety, protection against electric shock
Part 420: Protection for safety, protection against thermal effects
Part 430: Protection of cables and conductors for over-current
Part 450: Protection for safety, protection against undervoltage
Part 470: Protection for safety; use of protection for safety
Part 5xx: Selecting and erecting electrical equipment
Part 520: Wiring systems
Part 540: Earthing, protective conductor, potential bonding conductor
Part 560: Electrical equipment for safety purposes
EN 60439
IEC 60439
DIN EN 60439
VDE 0660-500
Low-voltage switchgear assemblies;
Part 1: Type-tested and partially type-tested assemblies
EN 60529
IEC 60529
DIN EN 60529
VDE 0470-1
Degrees of protection provided by enclosures (IP code)
EN 60721-3-x
IEC 60721-3-x
DIN EN 60721-3-x
Classification of environmental conditions
Part 3-0: Classification of environmental parameters and their severities; Introduction
Part 3-1: Classification of environmental parameters and their severities; Long-term storage
Part 3-2: Classification of environmental parameters and their severities; Transport
Part 3-3: Classification of environmental parameters and their severities; stationary use, weather
protected
EN 60947-x-x
IEC 60947 -x-x
DIN EN 60947-x-x
VDE 0660-x
Low-voltage switchgear
EN 61000-6-x
IEC 61000-6-x
DIN EN 61000-6-x
VDE 0839-6-x
Electromagnetic compatibility (EMC)
Part 6-1: Generic standard; Immunity for residential, commercial and light-industrial environments
Part 6-2: Generic standards; Immunity for industrial environments
Part 6-3: Generic standards; Generic standard emission for residential, commercial and light-
industrial environments
Part 6-4: Generic standards; Generic standard noise emission for industrial environments
EN 61140
IEC 61140
DIN EN 61140
VDE 0140-1
Protection against electric shock; Common aspects for installation and equipment
EN 61800-2
IEC 61800-2
DIN EN 61800-2
VDE 0160-102
Adjustable-speed electrical power drive systems;
Part 2: General requirements - Rating specifications for low-voltage adjustable frequency a.c.
power drive systems
EN 61800-3
IEC 61800-3
DIN EN 61800-3
VDE 0160-103
Adjustable-speed electrical power drive systems;
Part 3: EMC - Requirements and specific test methods
To Next Page
Loading...
