S120 Combi Power Modules
3.3 Interface description
SINAMICS S120 Combi
Manual, Edition 07/2012, 6SL3097-4AV00-0BP3
73
Note
DRIVE-CLiQ interface X204
For 3 axes Power Modules of the S120 Combi, there is no DRIVE-CLiQ interface X204.
Inserting and removing the DRIVE-CLiQ blanking covers
The blanking covers should not be inserted in the DRIVE-CLiQ interfaces that are not
required until the wiring work has been completed.
To remove the blanking covers, we recommend that the guiding frame is dismantled. For this
purpose unscrew the Torx slotted screw (see below).
Figure 3-7 Dismantling the guiding frame of the DRIVE-CLiQ interfaces
As an alternative to dismantling the guiding frame, flat-nosed pliers can be used to remove
the blanking covers.
To Next Page
Loading...
