Siemens SINUMERIK 804D sl

Introduction
1.2 Principle representation of SINUMERIK 840D sl components for commissioning
CNC Part 1 (NCK, PLC, drive)
16 Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
Commissioning NCU 7x0 with internal HMI
The following figure illustrates an example of a hardware and software arrangement for the
commissioning of an NCU 7x0 with internal HMI.

(WKHUQHW
67(3
6,0$7,&0DQDJHU
1&8[
+0,(PEHGGHG
6KRS0LOO6KRS7XUQ
7&8
&RPPLVVLRQLQJ
VRIWZDUH
6ZLWFK
(WKHUQHW
;

1&8[
+0,VO
$FWXDWRUPXOWL
D[LVFRQWURO
1&.
3/&
0&3
Figure 1-2 Principle representation SINUMERIK 840D sl