Siemens SINUMERIK 804D sl

Introduction
1.2 Principle representation of SINUMERIK 840D sl components for commissioning
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
17
Commissioning NCU 7x0 with external HMI
The following figure illustrates an example of a hardware and software arrangement for the
commissioning of an NCU 7x0 with PCU 50.3 with external HMI.

(WKHUQHW
$FWXDWRUPXOWL
D[LVFRQWURO
1&.
3/&
1&8[
(WKHUQHW
67(3
6,0$7,&0DQDJHU
;
1&8[
3&8
ದ:LQGRZV;33URI
ದ+0,$GYDQFHG
ದ6KRS0LOO6KRS7XUQ
&RPPLVVLRQLQJ
VRIWZDUH
ದ+0,VO
;
0&3
Figure 1-3 Principle representation of SINUMERIK 840D sl with PCU 50.3