NCK start-up
10.6 Parameterization of spindle data
CNC Part 1 (NCK, PLC, drive)
176 Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
DB number Bit, byte Name Reference
31, ... 83.2 Setpoint speed increased
31, ... 83.1 Setpoint speed limited
31, ... 83.0 Speed limit exceeded
31, ... 84.7 Active spindle control mode
31, ... 84.6 Active spindle mode oscillation mode
31, ... 84.5 Active spindle positioning mode
31, ... 84.3 Rigid tapping active
31, ... 86 and 87 M function for spindle
31, ... 88-91 S function for spindle
To Next Page
Loading...
