Commissioning SINAMICS drives
8.6 Commissioning using a drive wizard
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
89
Figure 8-42 Menu "Drives > Configuration"
21. Select the drive module with the vertical softkeys "Drive+/Drive-" in order to configure
additional drive modules.
The configuration is again started with the vertical softkey "Change".
When you have completed the configuration, check the data for power supply in the next
step and change, if necessary.
To Next Page
Loading...
