Siemens SINUMERIK 840Di sl - Page 163

5
01/2008 Parameters operating area
5.1 Tool data
5
©Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 5-163
Required offset values
for inclined grinding
wheel with implicit
monitoring selection
F'
STC_TPG1
STC_TPG2
STC_TPG4
STC_TPG5
STC_TPG6
STC_TPG7
STC_TPG8
STC_TPG3
STC_TPG9
Minimum wheel radius
Minimum wheel width
Maximum speed
Max. surface speed
Angle of the inclined wheel
Other values must
be set to zero
G17:
G18:
G19:
Radius in X/Y
Radius in Z/X
Radius in Y/Z
F: Toolholder reference point
Required offset values
for inclined grinding
wheel with implicit
monitoring selection
F'
STC_TPG1
STC_TPG2
STC_TPG4
STC_TPG5
STC_TPG6
STC_TPG7
STC_TPG8
STC_TPG3
STC_TPG9
Minimum wheel radius
Minimum wheel width
Maximum speed
Max. surface speed
Angle of the inclined wheel
Other values must
be set to zero
G17:
G18:
G19:
Radius in X/Y
Radius in Z/X
Radius in Y/Z
F: Toolholder reference point
Base Length 2