Siemens SINUMERIK 840Di sl - Page 164

5
Parameters operating area 01/2008
5.1 Tool data
5
©Siemens AG 2008 All rights reserved.
5-164 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Required offset values of
a surface grinding wheel
without base dimension
for GWPS
STC_TPG1
STC_TPG2
STC_TPG4
STC_TPG5
STC_TPG6
STC_TPG7
STC_TPG8
STC_TPG3
STC_TPG9
Minimum wheel radius
Minimum wheel width
Maximum speed
Max. surface speed
Angle of the inclined wheel
Other values must
be set to zero
G17:
G18:
G19:
Radius in X/Y
Radius in Z/X
Radius in Y/Z
F: Toolholder reference point
F'
Base
Required offset values of a
facing wheel with
monitoring parameters
STC_TPG1
STC_TPG2
STC_TPG4
STC_TPG5
STC_TPG6
STC_TPG7
STC_TPG8
STC_TPG3
STC_TPG9
Minimum wheel radius
Minimum wheel width
Maximum speed
Max. surface speed
Angle of the inclined wheel
Other values must
be set to zero
G17:
G18:
G19:
Radius in X/Y
Radius in Z/X
Radius in Y/Z
F: Toolholder reference point
X
e.g.