Siemens SINUMERIK 840Di sl - Page 166

5
Parameters operating area 01/2008
5.1 Tool data
5
©Siemens AG 2008 All rights reserved.
5-166 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Required offset values
for a turning tool with
tool radius
compensation
X
P
X
P=S
G17:
G18:
G19:
Other values must
be set to zero
Tool parameter DP2 defines the tool nose position.
Any value between 1 and 9 can be entered.
Note:
Length 1, length 2 refer to point P for edge
• Group type 7xx (special tools):
700 Slotting saw
710 3D probe
711 Edge probe
730 Stop