Siemens SINUMERIK 840Di sl - Page 167

5
01/2008 Parameters operating area
5.1 Tool data
5
©Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 5-167
Required offset values
for slotting saw
• Type 700 (slotting saw)
G17:
S (L1) in Y
(L1) in Z
in (L2) Z
in (R) Y/Z
2
1
The offset data (TOA data) you can enter for tool type 700 "slotting
saw" are as follows:
Geometry Wear Base
Length compensation
Length 1 $TC_DP3 $TC_DP12 $TC_DP21 mm
Length 2 $TC_DP4 $TC_DP13 $TC_DP22 mm
Length 3 $TC_DP5 $TC_DP14 $TC_DP23 mm
Radius compensation
Diameter $TC_DP6 $TC_DP15 mm
Slot width b $TC_DP7 $TC_DP16 mm
Projection k $TC_DP8 $TC_DP17 mm
3D probe
Type 710
See /BNM/, User Manual, Measuring cycles
Stop
Type 730
The stop is used to position the material in turning machines with bar
feed. Only tool length compensation is important.