5
Parameters operating area 01/2008
5.1 Tool data
5
©Siemens AG 2008 All rights reserved.
5-168 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Calculation of tool
parameters
Types 1xx (milling cutters), 2xx (drills) and 5xx (turning tools) are
calculated according to the same scheme.
Several entries exist for the geometric variables (e.g., length 1 or
radius). These are added together to produce a value (e.g., total
length 1, total radius), which is then used for the calculations.
Tool parameter
number (P)
Significance Comment
1 Tool type For overview see list
2 Length of cutting edge only for turning tools
Geometry Length compensation
3 Length 1 Calculation according to type and
plane
4 Length 2
5 Length 3
Geometry Radius
6 Radius Does not apply to drills
7 Reserved
8 Reserved
9 Reserved
10 Reserved
11 Reserved
Wear Length and radius compensation
Radius compensation
12 Length 1
13 Length 2
14 Length 3
15 Radius
16 Reserved
17 Reserved
18 Reserved
19 Reserved
20 Reserved
To Next Page
Loading...
