5
01/2008 Parameters operating area
5.1 Tool data
5
©Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 5-169
Tool base dimension/
adapter
Length compensations
21 Length 1
22 Length 2
23 Length 3
Technology
24 Clearance angle For turning tools
25 Clearance angle
Offsets that are not required must be assigned the value 0 (= default
when the offset memory is set up).
The individual values of the offset memory (P1 to P25) can be read
and written by the program via system variables.
The tool offsets can be entered not only via the operator panel front
but also via the data input interface.
Calculation of tool base
dimensions for two-
dimensional millhead
Y
Y
Y
Length 1
reference point
reference point
DP1
DP6
DP3
To Next Page
Loading...
