Siemens SINUMERIK 840Di sl - Page 170

5
Parameters operating area 01/2008
5.1 Tool data
5
©Siemens AG 2008 All rights reserved.
5-170 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Calculation of tool base
dimensions for three-
dimensional millhead:
Y
Y
Y
Other values must
be set to zero
G18:
G19:
Radius in X/Y
Radius in Z/X
Radius in Y/Z
F'
Required length
compensation values for
turning tools:
Other values must
be set to zero
Length 1
Tool tip P
(Cutting edge 1 = D
reference point