Siemens SINUMERIK 840Di sl - Page 171

5
01/2008 Parameters operating area
5.1 Tool data
5
©Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 5-171
Turning tool with several
cutting edges - length
compensation:
Other values must be
set to zero
Length 1
reference point
e.g. G18: Z/X plane
(Cutting edge 1 = D )
Tool tip P
(Cutting edge 2 = D
)
Calculation of tool base
dimensions for turning
machine:
Other values must
be set to zero
Length 1 - Geometry
F´: Tool base
reference point
F: Toolholder
reference point
X
F'