5
Parameters operating area 01/2008
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
5-184 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Important!
The structure of the table is freely configurable
(configured by the machine manufacturer).
The example shows only one possible case:
Location (Pl)
Location number
Location state (P)
Location state
(one column is provided for each state)
For example
F = Location enabled
G = Location disabled
Z = Reserved for tool in buffer
B = Reserved for tool to be loaded
L = Left half location occupied
R = Right half location occupied
O = Upper half location occupied
U = Lower half location occupied
l = Left half location reserved
r = Right half location reserved
o = Upper half location reserved
u = Lower half location reserved
PTP
Type assigned to the location
Tool ID
Name of the tool
To Next Page
Loading...
