5
01/2008 Parameters operating area
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 5-185
Dupl
Number of replacement tool
TNo
Internal T numbers, which may be needed for reloading tool data.
PTT
Type of location assigned to the tool
W (8x)
Tool status
(one column is provided for each status)
No display = Replacement tool
A = Active tool
F = Tool enabled
G = Tool disabled
M = Tool is measured
V = Warning limit is reached
W = Tool is being changed
P = Tool is fixed-location-coded
E = Tool has been in use
R = Unloading marking ("radius")
B = Loading marking
S = Master tool
PV
Wear group assigned to the tool.
WTy
Tool type
Only some of the tool offsets are enabled for input, depending on the
tool type.
All other tool types are preset to a value of 0.
Geo – Len 1
Radius ...
Tool offsets such as length, radius, wear, monitoring data, etc.
Horizontal softkeys
Magazine
list
The first or most recently displayed magazine is shown in the
"Magazine list" together with all the tools which have been loaded.
You can access the next magazine by pressing the corresponding
vertical softkey.
Tool list
All tools which are stored as a set of data on the NC are displayed
(irrespective of whether they have been assigned to a magazine
location).
Load
A magazine location is assigned to the tool.
To Next Page
Loading...
