5
Parameters operating area 01/2008
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
5-186 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Unload
The tool is deleted from the current magazine location.
Relocate
The tool is moved from the current magazine location to another
location.
Working
offset
The cutting edges of active replacement tools are displayed. They are
sorted in order of ascending D numbers.
Further softkeys are displayed when you press the "ETC." key:
Tool
catalog
You can create new tool master data ("ideal" tools) and edit the
existing data.
Tool
cabinet
You can create new tool offset data and tool operating data ("real"
tools) and edit the existing data.
Trans-
formation
This softkey allows you to display the tool data as transformed data
(adapter data are calculated) or non-transformed data.
This conversion feature is only available in the magazine list display.
The data are always displayed as non-transformed data in the tool list
and as transformed data in the working offset list.
Special feature: If you display transformed data and want to create a new tool in the
magazine list (loading mode), the transformed data display is
activated exclusively for input of this data block.
(Names assigned by
user)
Vertical softkeys (magazine list)
Selection of user-specific display windows (if configured), e.g.,
Magazine
list 1
• General data
Magazine
list 2
• Geometry data
Magazine
list 3
• Wear data
To Next Page
Loading...
