Siemens SINUMERIK 840Di sl - Page 196

5
Parameters operating area 01/2008
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
5-196 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Symbols
/
The G56 reset value is TOWMCS
/ and
$SC_WEAR_TRANSFORM is set.
The current tool for channel "REV2" is indicated in row 2. The current
value of G56 on channel "REV2" deviates from the G56 reset value
(
).
Row 11 displays the current tool for channel "HAND". There the
current value of G56 is equal to the reset value (
).