Siemens SINUMERIK 840Di sl - Page 216

5
Parameters operating area 01/2008
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
5-216 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
II.
Hit list
in the "Loading list" and
"Standard list" screens
The "Hit list" screen has one of 2 configuration-dependent variants:
• Loading list with the functions "Load" and "Reactivate"
• Standard list with the functions "Reactivate", "Unload", "Delete",
"In cabinet".
When filtering has started in screen 1 "Filter selection", the tools found
in screen 2 "Hit list" are displayed in a list with one line per tool.
The data are a snapshot created at the time of filtering; it is not
updated later when the data in the NC change.
Selection
of tools
No tool is selected for batch processing at the
outset. By positioning the cursor and pressing the Select key, you can
toggle the tool selection for batch processing. To change the tool
selection for batch processing, you can use the "Select all" and
"Deselect" softkeys.
Selected tools are represented in color and also indicated by a symbol
in the 2nd column of the hit list on the display screen.
In the standard setting, a tool selected for batch processing is
displayed with a checkbox that has been selected (
and ).
The color for "Cursor" and for "Selected for batch processing" is
identical and corresponds to the general selection display.
When selection of the tools is completed, press the softkey to start the
batch function.