5
01/2008 Parameters operating area
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 5-217
Start
batch function
"Load"
Vertical softkeys
Select all
All tools in the hit list are selected for batch processing.
Cancel
selection
The selection for batch processing is canceled for all tools in the hit
list.
Load
"Loading" is initiated as a batch command for the selected tools. You
are prompted to enter the destination magazine and the load point in a
dialog box.
Reactivate
"Reactivate" is initiated as a batch command for the selected tools.
When reactivating a tool, the monitoring actual values and the wear
are reset. You can use the INI file (entry
n_ReactivatePositioningMode) to specify (for each filter)
whether reactivation is to be carried out "always", "never", or "on
request" with magazine positioning. Depending on the setting, the
dialog box prompts for positioning and the load point as appropriate to
the setting.
To Next Page
Loading...
