7
Services operating area 01/2008
7.1 Services main screen
7
© Siemens AG 2008 All rights reserved.
7-360 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Notice: Data may only be loaded for programs for which an enable
has been set!
Length
File length in bytes (directory length is not displayed)
Date
Date of creation or date of last modification to file
Enable
Enable (=selection/right to execute) activated "X" or not activated " "
When you set up a program, you may not necessarily be able to
process it immediately with an NC Start (e.g. if it is not ready or
requires a trial run).
To indicate that a program is ready for NC Start, it is possible to
enable or disable the program. The current state of a file is indicated
by an "X" in the "Enable" column (= enable activated).
Access authorization There are also 5 access rights for each file:
• Delete Corresponds to level 1
• Display Corresponds to level 2
• Write Corresponds to level 3
• Read Corresponds to level 5
• Execute Corresponds to level 7
The access right for each file is indicated in the file tree. Not every
user should be able to edit data and programs on the control. Access
levels are therefore defined for each file. They range from level 0
(SIEMENS password) to level 7 (key-operated switch 0).
For how to set the access rights, see Chapter "Changing properties".
The access rights are not displayed as the numbers 1 − 7 in the
display, instead the display only includes objects which can be
executed depending on the rights assigned when the control was
started.
To Next Page
Loading...
