Siemens SINUMERIK 840Di sl - Page 407

8
01/2008 Diagnostics operating area
8.4 Service displays
8
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 8-407
• Driver state
Status code:
[0] "Not initialized"
[1] "Establish communication after booting"
[2] "Establish communication after error"
[3] "Wait for checkback signals SN=1"
[4] "Receiver waits for user acknowledgement"
[5] "Normal operation"
Vertical softkeys:
"Connection +" softkey
Changes to the next send connection (F_SENDDP).
If less than 2 connections are configured, then this softkey is not
displayed.
"Connection −" softkey
Changes to the previous send connection (F_SENDDP).
If less than 2 connections are configured, then this softkey is not
displayed.
“General” softkey
Displays the “SI communication (general)” dialog box.
“Send connection”
softkey
This means that you change to the “SI communication (send)” dialog
box.
“Receive connection”
softkey
This means that you change to the “SI communication (receive)”
dialog box.
"Display
SPL connection" softkey
This means that you change to the “Details, SPL connection (send)”
dialog box.
This softkey can only be selected if send connections have been
configured.
"Display connection"
softkey
This means that you change to the “SI communication (send)” dialog
box.