2
Operator Components/Operating Sequences 01/2008
2.4 Screen layout
2
©Siemens AG 2008 All rights reserved.
2-46 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
49 Wait: For axis replacement: Axis currently coupled
50 Wait: For axis replacement: Lift fast active
51 Wait: For axis replacement: New-Config active
52 Wait: For axis replacement: Axis container rotation active
53 Wait: For axis replacement: Waitp active
54 Wait: For axis replacement: Axis is currently in another
channel
55 Wait: For axis replacement: Axis is currently a PLC axis
56 Wait: For axis replacement: Axis is currently an oscillating
axis
57 Wait: For axis replacement: Axis is currently a JOG axis
58 Wait: For axis replacement: Axis is currently a command
axis
59 Wait: For axis replacement: Axis is currently an OEM axis
60 Wait: For axis replacement: Axis is currently a slave axis
coupled to the master value
61 Wait: For axis replacement: Axis is currently a coupled-
motion slave axis
62 Wait: For axis replacement: Axis is currently a coupled
slave axis
4 Channel name Name of the channel in which the program is running.
5 Alarm and message line - Alarms and messages or
- Instructions that were programmed in the part program using the
MSG command (if no alarms are active)
6 Operating mode display The currently selected operating mode, i.e. JOG, MDA or AUTO
(automatic) is displayed.
The active submode is displayed next to the operating mode. An
active increment is also displayed underneath, e.g.,
JOG Repos
1000
7 Program name Press NC Start to execute this program.
The "Program name" output field can be configured for JOG and MDA
(see machine manufacturer's specifications).
To Next Page
Loading...
