2
Operator Components/Operating Sequences 01/2008
2.5 General operating sequences
2
©Siemens AG 2008 All rights reserved.
2-56 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Cursor block:
Use the "Direction keys" to position the cursor in the text.
You can page up and down using the "Page" keys.
The character on which the cursor is positioned is deleted.
Press the "Backspace" key to delete the character to the left of the
cursor.
Press the "Input" key to end a block. "L
F
" ("Line Feed") is
automatically generated.
Vertical softkeys
Over-
write
Overwrite
The cursor toggles between insert and overwrite modes.
Mark
block
Select block
When you press this softkey, the vertical softkey bar changes. The
softkey marks the beginning of a block.
Now position the cursor at the end of the block.
The block is selected automatically.
Copy
block
This softkey copies the selected block into the buffer.
If a line, which was generated by a support function, is selected the
complete support block is copied.
It remains stored in the buffer even if another part program
is selected.
Delete
block
The selected block is deleted.
If a line that was generated by a support function is selected the
complete support block is deleted.
Mark
block
Selection mode is canceled when you press "Select block".
Paste
block
Paste block
This softkey pastes the cut or copied block from the buffer into the text
in front of the cursor position.
To Next Page
Loading...
