2
01/2008 Operator Components/Operating Sequences
2.5 General operating sequences
2
©Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 2-57
Find/
Go to...
Find/Go to...
The “Find/Go to…” dialog box opens. You can select functions for
positioning and searching via the vertical softkeys:
Program
start
Program
end
Go to...
Find
The following search methods are available:
• Search to the beginning of the part program (cursor on the first
character in the program)
• Search to the end of the part program (cursor on the last character
in the program) and
• Proceed to a particular NC block with "Go to.."
• Or search for a particular character string with "Find".
"Go to...": Enter the block number you are looking for.
• If the line being searched for contains an "N" or ":", you are taken
to the block in question.
• A message is output if there is no block with the specified number.
OK
Press the "OK" softkey or the "Input" key to position the cursor on the
block number/line number of your choice.
The "Go to..." window is closed.
Abort
If you press “Abort” the positioning process is stopped and the window
closed.
"Find":
Enter the character string you wish to find.
The string you enter is sought downwards from the current cursor
position, the find result appears as highlighted text.
Find
next
or
You can start a new search by pressing the "Find Next" softkey or the
"Input" key.
Replace
or
Enter the new text with the "Replace" softkey.
The text found is replaced by the "replacement text". The new text is
replaced when you press "Input". Every time you press "Input", a new
find and replace process is started.
Replace
all texts
Enter the new text with the "Replace All" softkey. The query asks you
"Do you really want to replace all non-write-protected strings: ...
globally with ... ?".
Note:
This function can be interlocked with a password (see Commissioning
Manual HMI Advanced).
To Next Page
Loading...
