2
Operator Components/Operating Sequences 01/2008
2.5 General operating sequences
2
©Siemens AG 2008 All rights reserved.
2-58 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
The function "Replace All" is only enabled for files located on the hard
drive (i.e., not in the NC memory).
Abort
If you press “Abort”, the Find + Replace process is stopped and the
window closed. You are back in "Edit mode" again".
Save
file
Save File
Changes are saved in the file loaded in the editor.
Additional information
Please note that the changes to programs stored in the NC memory
take immediate effect.
The save options for the control system can be altered in the
"Settings" menu (e.g., save automatically, etc.).
(See Chapter "Startup")
Close
editor
Close editor
When you select the "Close editor" softkey, a dialog box may appear
in which you must confirm whether or not to save the changes. The
text editor is then closed and the current program overview is
displayed again.
Horizontal softkeys
Free contour programming
Contour
Generate
contour
Use the "Contour" and "Generate contour" softkeys to call up the free
contour programming function.
Accept
contour
The part program block is inserted in the part programs with the
appropriate parameter settings.
Cycle parameterization
The following programming support functions are available:
• Drilling, milling, turning (cycles)
• Contouring (free contour programming)
Drilling
Milling
Turning
You can call up the relevant cycle parameter settings via the Drilling,
Milling, Turning vertical softkeys.
Enter the new values for the cycle parameters.
OK
The part program block is inserted in the part programs with the
appropriate parameter settings.
Example:
CYCLE81 (110, 100, 2, 35)
To Next Page
Loading...
