Smartrise HYDRO:EVOLVED

Hydro:Evolved User Manual
October 2022 ©2022 Smartrise Engineering, Inc. All Rights Reserved Page ix
25.2 Retain Parameters for a Replaced CT or COP Board .............................................. 210
26 Hoistway Access........................................................................................ 211
27 Miscellaneous ........................................................................................... 216
27.1 Bypass Term Limit ................................................................................................ 216
27.2 Enable Construction Box ...................................................................................... 216
27.3 Maximum Run Time ............................................................................................. 217
27.4 CT Insp. Req. IC .................................................................................................... 218
27.5 Dis. IdleTrvArrow ................................................................................................. 218
27.6 Enable Latches Car Calls ....................................................................................... 219
27.7 Car To Lobby Floor ............................................................................................... 219
27.8 Parking ................................................................................................................ 220
27.8.1 GUI Parking ........................................................................................................... 220
27.8.1 Parking Timer ........................................................................................................ 221
27.8.2 Parking Floor ......................................................................................................... 222
27.8.3 Parking Door Open ................................................................................................ 222
27.9 OOS ..................................................................................................................... 223
27.9.1 Disable OSS ........................................................................................................... 223
27.9.2 Hourly Fault Limit .................................................................................................. 224
27.9.3 Maximum Starts Per Minute ................................................................................. 224
27.9.4 Disable PI OOS ....................................................................................................... 225
27.10 En. 3 Digit PI ........................................................................................................ 226
27.11 Payment Passcode ............................................................................................... 226
27.12 Direct Change Delay ............................................................................................. 227
27.13 Default ................................................................................................................ 227
27.13.1 Default Floors .................................................................................................... 228
27.13.2 Default S-Curve ................................................................................................. 229
27.13.3 Default Run Timers ............................................................................................ 229
27.13.4 Default I/O ......................................................................................................... 230
27.13.5 Default Other..................................................................................................... 231
27.13.6 Default Factory .................................................................................................. 232
27.13.7 Default FRAM .................................................................................................... 232
28 Swing Operation ....................................................................................... 234
28.1 Configuring Swing Operation Input ...................................................................... 234
28.2 Calls Enable Swing ............................................................................................... 234