Hydro:Evolved User Manual
October 2022 © 2022 Smartrise Engineering, Inc. All Rights Reserved Page 307
From THE ENTER CAR CALL menu, scroll to view the latched car calls.
Figure 599: ENTER CAR CALL Menu
38.3 Enter Hall Calls
Enter Hall Call allows the user to enter Hall Calls to the group from the MR board.
The following procedure describes how to enter hall calls.
Navigate to MAIN MENU | DEBUG | ENTER HALL CALLS. See Figure 62.
From the HALL CALL menu, enter hall call.
Figure 600: Hall Call Menu
The Hall Call Mask menu allows:
• Landing – The user to select the landing (this is not based on PI Labels, but landing-
based as in 1 is the first floor, 2 is the second floor, etc.
• Dir – The controller to know which direction the request is made for (DN for Down, UP
for Up).
• Mask Value – The mask of the function the user wants. For example, by default all jobs
use a mask value of 1 for front hall calls. The user will change the mask value to 1 to
initiate a front hall call. When these three are set (Land, Dir, Mask), the user must press
the middle/enter button to send the information.
• Latched – Shows what mask value has been accepted into the dispatching.
38.4 Enter Door Command
The Enter Door Command allows the user to assert a Door Open, Door Close, or Nudge
commands from any of the MR, CT, or COP boards if the car is idle, unfaulted, and safe.
Navigate to MAIN MENU | DEBUG | ENTER DOOR COMMAND. See Figure 62.
To Next Page
Loading...
Need help?
General
