EasyManuals Logo

Smartrise HYDRO:EVOLVED User Manual

Default Icon
357 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #323 background imageLoading...
Page #323 background image
Hydro:Evolved User Manual
October 2022 © 2022 Smartrise Engineering, Inc. All Rights Reserved Page 289
The following is a list of Car Commands (Status) within the E-POWER COMMAND Menu.
Off Emergency power is not active.
Precall Command is issued briefly to check the car’s underlying mode of operation. It
should prevent the car from moving. This command is issued to allow the car to report
its mode during E-Power OOS operations.
Recall The car is being commanded to go to its recall floor and remain there with
doors open.
Auto The car is being commanded to run normally, for example, the car is selected to
run.
OOS The car is being commanded to emergency stop if in motion and remain faulted
where it is until further commands are issued. This command is issued when a car is
awaiting recall or has failed to recall. It is also issued if the up to speed input is missing.
Pretransfer The car is being commanded to ramp down to the nearest landing if in
motion and remain there with doors open until further commands are issued. This is
issued when the pretransfer input is active.
The following is a list of Group State (mode) within the E-POWER COMMAND Menu. This
section of the menu can be viewed when scrolling down.
Off The car group is not on emergency power.
On Group cars are being held out of service, awaiting the signals necessary to begin
recall.
Recall Group cars are being recalled.
Run Car Group cars are being selected to run.
Pretransfer - Group is in a pretransfer state due to the pretransfer input being active.
Typically used to stop cars prior to transferring from generator power back to main line
power.
32.10 EMS Status
The following procedure describes how to view the EMS status.
Navigate to MAIN MENU | STATUS | EMS STATUS. See Figure 49.
From the EMS STATUS menu, scroll and view the status of the EMS hall calls assigned to
the cars. An EMS hall call is assigned to the nearest car configured to take these calls.
NOTE: If a car is not assigned as EMS, the communication status displays NONE.
Figure 554: EMS STATUS Menu Car 1 Assigned

Table of Contents

Other manuals for Smartrise HYDRO:EVOLVED

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Smartrise HYDRO:EVOLVED and is the answer not in the manual?

Smartrise HYDRO:EVOLVED Specifications

General IconGeneral
BrandSmartrise
ModelHYDRO:EVOLVED
CategoryController
LanguageEnglish

Related product manuals