Fastening the seat belt
DANGER
Mortal danger when driving without wearing a seat
belt!
If the seat belt is not fastened and the truck tips over
or crashes into an obstacle, the driver can be thrown
out of the truck. The driver could slide under the
truck or collide with an obstacle.
– Fasten the seat belt before every trip.
– Do not twist the seat belt when fastening it.
– Only use the seat belt to secure one person!
– Have any malfunctions repaired by the authorised
service centre.
NOTE
The buckle has a buckle switch. When the belt
was not fastened, the following occurred:
●
The message
Close seat belt
appears on the display-operating unit.
●
The truck will not drive at speeds faster
than 4 km/h.
●
The hydraulic functions are blocked.
NOTE
One variant prevents the truck from being driv-
en at all if the seatbelt is not fastened. The
message
Close seat belt
appears
on the display.
– Pull the seat belt (3) smoothly out of the belt
retractor and place over the thighs close to
the body.
NOTE
Sit back as far as possible so that your back is
resting on the seat backrest. The automatic
blocking mechanism permits sufficient free-
dom of movement on the seat.
– Click the belt tongue (2) into the buckle (1).
– Check the tension of the seat belt. The belt
must fit closely around your body.
7311_003-048
1
2
3
Operation
4
Driver's seat
11556368011531 EN - 01/2021 - 05
To Next Page
