Still 6219 - Medical Equipment

●
Changing rim wheel parts
●
Combining rim wheel parts from different
manufacturers
Therefore, the above-mentioned factors are
prohibited .
The following rules must be observed to en-
sure stability:
– Only use tyres with equal and permitted lev-
els of wear on the same axle.
– Only use wheels and tyres of the same type
on the same axle, e.g. only superelastic
tyres.
– Only use wheels and tyres approved by the
manufacturer.
– Only use high-quality products.
Wheels and tyres approved by the manufac-
turer can be found on the spare parts list. If
other wheels or tyres are to be used, authori-
sation from the manufacturer must be ob-
tained beforehand.
NOTE
Check with the authorised service centre be-
fore changing over to a different tyre size.
When changing wheels or tyres, ensure that
the truck is not tilting. Always change wheels
on the right and left (e.g.) at the same time.
Changes must only be made following consul-
tation with the manufacturer.
If the type of tyre used on an axle is changed,
for example from superelastic tyres to pneu-
matic tyres, the load diagram must be
changed accordingly.
– Contact the authorised service centre re-
garding this matter.
Medical equipment
WARNING
Electromagnetic interference may occur on medical
devices!
Only use equipment that is sufficiently protected
against electromagnetic interference.
Safety
2
Basic principles for safe operation
4956368011531 EN - 01/2021 - 05