Changing to a different battery type
The truck can be converted to a different bat-
tery type and capacity.
The new battery capacity and new battery
type must be set in the display-operating unit.
●
If this is not done, the actual battery dis-
charge status cannot be determined. The
battery charge level is not displayed cor-
rectly.
●
In the worst case scenario, deep discharge
can damage the battery.
Using his/her access authorisation, the fleet
manager can set the new battery capacity and
the new battery type in the display-operating
unit.
NOTE
When changing to TENSOR
®
batteries, the
authorised service centre must limit the maxi-
mum speed of the truck to 17 km/h for techni-
cal reasons.
Setting the new battery capacity and the
new battery type
– Stop the truck.
– Actuate the parking brake.
– Press the button
.
– Press the "Settings" softkey
.
The first menu level appears.
– Activate the "Access authorisation for the
fleet manager".
The "Settings menu" opens on the display.
– Press the
Truck settings
softkey .
– Press the
Battery
softkey.
– Press the
Battery type
softkey.
The possible batteries for the truck are listed
in the "Battery type" menu.
– Press the corresponding softkey for the de-
sired battery type.
The activation bar next to the selection lights
up.
Operation
4
Replacing and transporting the battery
408 56368011531 EN - 01/2021 - 05
To Next Page
Loading...
